Adding the Brain

I need to equip the new plane with a brain and servos. This plane will require nine servos. All servos come from ProModeler. Rather than use some of the more name brand servos, I decided to go with this small business that specializes in servos for military drones. It’s a great, local business where the owner is happy to talk to you, and he stands behind his products.

First up, it’s time to make some servo extensions. I like to make my own rather than buy them. By making my own, I can get the exact length I want. I figure there will be somewhere north of 30ft of extensions in this plane.

Here are the tools:

IMG_0586.jpg

Everything came from Hansen Hobbies. Time to start crimping since there are lots of extensions to make.

  • 2x for the elevators

  • 2x for the rudder

  • 2x wire harnesses for the two aileron servos using an MPX connector

  • 1x for the throttle

  • 2x for the ignition Tech Aero IBECs.

  • 2x for the cylinder head temperature sensors

I am using 20AWG wire instead of the usual 22AWG wire because my wire lengths are so long. It makes building the servo connectors a little tricky. One trick I use is to use a fresh blade and trim any excess insulation off the wire before pushing it into the connector. Otherwise, the extra insulation makes it really difficult to push into the connector.

IMG_0607.jpg

Need to do a little soldering to build the wire harnesses for the ailerons. Since each wing panel has two servos, I want a simple, foolproof solution for plugging in each wing panel. The MPX connectors have 8 pins. I will use 6 to allow for two servos per connector.

IMG_0611.jpg

Now I have some wires, it’s time to install some servos.

IMG_0609.jpg

Adding the receiver into the void so all these servos have a brain. You can also see the MPX connecters on the left and right sides of the photo. This is where the ailerons will be plugged into when the wings are attached. I still need to add some more wire keepers to clean things up and add the redundant power, but this is starting to work now.

IMG_0633.jpg

Finally, we can see something move. Here is the rudder. Note, this required balancing the two servos to work in unison. Otherwise, these servos are strong enough to rip the arm right out of the rudder. Each servo can lift nearly 40lbs!